CALCULATE YOUR CONSUMPTION
Algisur B-S
Damp Wall Treatment
• Anti-rising damp barrier for treating damp walls
• Injected at the base of the wall, the product diffuses throughout the wall thickness
• The formulation creates a true waterproof barrier
• Acts effectively in the core of the material
• Permanent protection
• Walls can be overcoated in 3 to 4 months
TYPES OF SUPPORT:
All types of walls: concrete, bricks, stones, cinder blocks, etc.
Do not apply on glass, wood, plastics, aluminum, or metals
OTHER FEATURES:
Packaging: 30 L
Coverage: 1 litre = approximately 5 m²
Drilling the injection holes:
1. Always drill above ground level
2. Mark two horizontal lines with a chalk line, 15 cm apart maximum, with the lower line at 20 cm from the floor
3. On each line, drill staggered holes, to 3/4 of the wall thickness, angled downward (20–30°), 16 mm in diameter, spaced maximum 30 cm apart
4. For walls thicker than 45 cm, drill on both sides if possible (interior and exterior); in this case, limit the depth to 2/3 of the wall thickness
5. After drilling, remove dust from the hole using the drill bit
Product injection:
6. The product can be injected using a manual or electric sprayer
7. Insert the lance to the bottom of the hole, inject the product for 4–5 seconds maximum (less if the product overflows), then remove the lance
8. Repeat the operation for each hole
9. 15–30 minutes after the first injection, repeat the injection series as before (plan 3–4 passes)
10. For hollow block walls, limit injections to 3 consecutive series, 30 minutes apart
11. Fill the holes after the product has completely dried (24–48 hours)
• In case of accidental splashes, especially on aluminum or glass, rinse immediately with water
• Wait 3–4 months before repainting or wallpapering
• Store in a frost-free area
CALCULATE YOUR CONSUMPTION
